Sony STR-DN2010 - Manual (Page 119)

119 GB
D:\NORM'S JOB\SONY HA\SO0071\STR-DN2010\GB\GB05ENJ_STR-DN2010-CEL.fm masterpage: Right
STR-DN2010
4-182-049-11(1)
Adj
u
s
tin
g Setti
ng
s
4 Press V/v repeatedly to select the IP
address, then press .
The soft keyboard appears on the TV
screen.
5 Press V/v/B/b and to select a
character one by one to enter the IP
address.
6 Press V/v/B/b to select “Finish”, then
press .
7 Press b to display the next screen.
8 Repeat the process in steps 4 to 7
again to enter the Subnet Mask,
Gateway address, DNS1 address, and
DNS2 address.
9 Press V/v repeatedly to select “Test
Connection”, then press .
“Success! The receiver is now connected to
network.” appears on the TV screen.
10 Press to select “Finish”.
To set the Proxy server
manually
1 Press V/v repeatedly to select
“Network Setup”, then press .
2 Press V/v repeatedly to select “Proxy
Setup”, then press .
3 Press V/v repeatedly to select
“Enable”, then press .
4 Press .
The soft keyboard appears on the TV
screen.
5 Press V/v/B/b and to select a
character one by one to enter the proxy
server address.
6 Press V/v/B/b repeatedly to select
“Finish”, then press .
7 Press b to select the Port number box,
then press .
The soft keyboard appears on the TV
screen.
8 Press V/v/B/b and to select a
character one by one to enter the port
number.
9 Press V/v/B/b repeatedly to select
“Finish”, then press .
10 Press b.
11 Press V/v repeatedly to select “Finish”,
then press .
Lets you turn the function which controls the
receiver from external controllers on the home
network on or off.
x OFF
x ON
Note
If you set “Controllers”, set “External Control” to
“ON”.
Lets you set availability of operations allowed
for the receiver for network controllers on the
home network that have attempted to access
the receiver in the past.
1 Press V/v repeatedly to select
“Controllers”, then press .
The setting screen used for Controllers
appears on the TV screen.
2 Press V/v repeatedly to select the
controller you want to allow to operate
the receiver from the list, then press
to check the box.
When you check the box for “Auto
Permission”, all the controllers detected are
checked automatically.
3 Press V/v/B/b repeatedly to select
“Finish”, then press .
External Control
Controllers
continued