Sony STR-DN2010 - Manual (Page 143)

143 GB
D:\NORM'S JOB\SONY HA\SO0071\STR-DN2010\GB\GB07ADD_STR-DN2010-CEL.fm masterpage: Right
STR-DN2010
4-182-049-11(1)
Ad
ditional Inf
o
rmation
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
Cannot find the server.
• Search the server using the
“ServerSearch” function (page 79).
• Check the following:
– Is the router turned on?
– If there is another device between this
device and the router, check that device
is turned on.
– Are all of the cables connected correctly
and securely?
– Is the settings to make sure that they
match the router’s settings (DHCP or
fixed IP address)?
• When using a computer, check the
following:
– The built-in firewall settings for the
computer’s operating system.
– The firewall settings of your security
software. To check the firewall settings
of your security software, refer to your
security software’s Help section.
• Register this device with the server. For
details, refer to the operating instructions
supplied with the server.
• Wait for a few moments, and then try
connecting to the server again.
Cannot find or play back the content on
the server.
• On the “ Music”, “ Photo”, and
“ Video” screens, the receiver displays
only the content that can be played back
with the receiver from among the content
offered by the server within the DLNA
guidelines.
• The content without a [*] mark before the
name is offered by the server as that
defined in the DLNA guidelines, and it can
be played back with the receiver.
The content with a [*] mark before the
name is offered by the server as that not
defined in the DLNA guidelines, and it
may be played back with the receiver.
• There may be content that is not displayed
even if it can be played back with the
receiver because it is not defined in the
DLNA guidelines. However, the receiver
may not be able to play back the content,
even if it is defined in the DLNA
guidelines.
• The availability of certain content may
differ, depending on the server software. If
the content is not displayed or cannot be
played back, try the supplied VAIO Media
plus application software as your server
software.
Cannot connect to the receiver with the
Setup Manager application software.
• Does antivirus software, firewall software,
or a network packet filter driver run on
your computer?
Deactivate such software temporarily, or
change the settings to accept all incoming
TCP or UDP packets from the receiver.
Cannot access the receiver from the
network controller.
• Make sure “External Control” is set to
“ON” in Network Settings menu.
Remote commander
Network
continued