Sony STR-DN2010 - Manual (Page 41)

41 GB
D:\NORM'S JOB\SONY HA\SO0071\STR-DN2010\GB\GB04GET_STR-DN2010-CEL.fm masterpage: Right
STR-DN2010
4-182-049-11(1)
Pre
p
ar
ing the
R
eceive
r
3
Press V/v repeatedly to select
“Speaker”, then press .
4
Press V/v repeatedly to select
“Speaker Pattern”, then press
.
5
Press V/v repeatedly to select
the speaker pattern you want,
then press
.
6
Press RETURN/EXIT O.
You can switch the usage of the speaker(s)
connected to the SPEAKERS SURROUND
BACK/FRONT HIGH/BI-AMP/FRONT B
terminals in accordance with the intended use.
Notes
• This setting is only available if the “Speaker
Pattern” is set to a setting without surround back
and front high speakers.
• Be sure to set “Sur Back Assign” before you
perform Auto Calibration.
1
Press GUI MODE.
After “GUI ON” appears on the display
for a while, the GUI menu appears on the
TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
2
Press V/v repeatedly to select
“ Settings”, then press or
b.
The Settings menu list appears on the TV
screen.
3
Press V/v repeatedly to select
“Speaker”, then press .
4
Press V/v repeatedly to select
“Sur Back Assign”, then press
.
5
Press V/v repeatedly to select
the parameter you want, then
press .
• OFF
If you connect surround back or front
high speakers to the SPEAKERS
SURROUND BACK/FRONT HIGH/
BI-AMP/FRONT B terminals, select
“OFF”.
• BI-AMP
If you connect front speakers to the
SPEAKERS SURROUND BACK/
FRONT HIGH/BI-AMP/FRONT B
terminals using a bi-amplifier
connection, select “BI-AMP”.
• SPEAKER B
If you connect an additional front
speaker system to the SPEAKERS
SURROUND BACK/FRONT HIGH/
BI-AMP/FRONT B terminals, select
“SPEAKER B”.
6
Press RETURN/EXIT O.
Setting the surround back
speakers
Speaker Pattern
Sur Back Assign :
Manual Setup
Crossover Freq
Test Tone
D.Range Comp : AUTO
OFF
Speaker Settings
Speaker Pattern
3/4.1