Additional information, Precautions – Sony 3-299-549-11(1) User Manual

Page 100

Advertising
background image

100

GB

On power sources

• Unplug the subwoofer from the wall outlet (mains) if

you do not intend to use it for an extended period of
time. To disconnect the cord, pull it out by the plug,
never by the cord.

On placement

• Place the system in a location with adequate

ventilation to prevent heat build-up in the system.

• At high volume, over long periods of time, the cabinet

becomes hot to touch. This is not a malfunction.
However, touching the cabinet should be avoided. Do
not place the control unit in a confined space where
ventilation is poor as this may cause overheating.

• Do not block the ventilation slots by putting anything

on the system. The system is equipped with a high
power amplifier. If the ventilation slots are blocked,
the control unit can overheat and malfunction.

• Do not place the control unit on surfaces (rugs,

blankets, etc.) or near materials (curtains, draperies)
that may block the ventilation slots.

• Do not install the control unit near heat sources such

as radiators, or air ducts, or in a place subject to direct
sunlight, excessive dust, mechanical vibration, or
shock.

• Do not install the control unit in an inclined position.

It is designed to be operated in a horizontal position
only.

• Keep the control unit and discs away from component

with strong magnets, such as microwave ovens, or
large loudspeakers.

• Do not place anything on the control unit and the

subwoofer.

• If you use more than one set of S-AIR products,

position them away from each other to avoid cross
talk.

• Install this surround amplifier and S-AIR products at

least 50 cm away from people.

• If you use more than one surround amplifier, do not

place one on top of the other.

On operation

• If the system is brought directly from a cold to a warm

location, or is placed in a very damp room, moisture
may condense on the lenses inside the control unit.
Should this occur, the system may not operate
properly. In this case, remove the disc and leave the
system turned on for about half an hour until the
moisture evaporates.

• When you move the system, take out any disc. If you

don’t, the disc may be damaged.

• If anything falls into the cabinet, unplug the

subwoofer and have it checked by qualified personnel
before operating it any further.

On adjusting volume

• Do not turn up the volume while listening to a section

with very low level inputs or no audio signals. If you
do, the speakers may be damaged when a peak level
section is suddenly played.

On cleaning

• Clean the cabinet, panel, and controls with a soft cloth

slightly moistened with a mild detergent solution. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
If you have any questions or problems concerning
your system, please consult your nearest Sony dealer.

• Clean the cabinets of the surround amplifier only with

a soft dry cloth. Do not use any type of abrasive pad,
scouring powder or solvent such as alcohol or
benzene.

On cleaning discs, disc/lens
cleaners

• Do not use cleaning discs or disc/lens cleaners

(including wet or spray types). These may cause the
apparatus to malfunction.

On your TV’s colour

• If the speakers should cause the TV screen to have

colour irregularity, turn off the TV then turn it on
after 15 to 30 minutes. If colour irregularity should
persist, place the speakers further away from the TV
set.

Additional Information

Precautions

Advertising