Samsung DVW-707/707P - Manual (Page 75)

Chapter 3 Recording and Playback
3-17
3
• The time code stops advancing while time data is being set (when the
F-RUN/SET/R-RUN switch is set to SET). For this reason, if you start
recording immediately after switching to F-RUN or R-RUN (i.e., to a
position other than SET), you may overwrite a portion of the
previously recorded time code.
• Recontinuation recording in Loop Rec mode is done in the same way
as normal recording. In Loop Rec mode, however, when recording is
recontinued, the Loop Rec time is subject to a decrease of up to 0.3
second. (DVW-707/709WS/790WS only)
Turning off the camera
• When you turn the POWER switch to OFF, the camera will turn off by
itself after the tape has run for a few seconds.
• If you remove the battery, pull out the DC cable, or cut the power to
the AC adaptor during recording, the image currently being shot on the
camcorder will not be recorded. For this reason, take care not to
change the battery while recording.
When the tape runs out during recording
Please note that picture data at the instant the tape stopped is not
recorded if the tape runs out and the camcorder stops. The recorded
picture data is interrupted before the recording stop point.