Sharp UX-600M - Manual (Page 104)

<P=002>
3
Gently pull the jammed paper out of the
printing compartment.
4
Replace the imaging film, making sure
that the flange goes into the rear slot on
the left side of the printing compartment.
Also, make sure that the right, rear gear
engages with the gear below it.
5
Wind the film slightly (rotate the gear on
the right side of the rear spool) so that
there is no slack in the film. Make sure
that both edges of the film wind onto the
spool evenly.
6
Close the print compartment cover, mak-
ing sure it clicks into place.
•
Caution! Close the cover slowly to
make sure it doesn’t pinch your fin-
gers.
Chapter 12 Troubleshooting
92