Sun Microsystems Netra 120 - Manual (Page 181)

Appendix A Installing and Removing a SCSI Hard Disk Drive with Solaris Running A-3
3. Connect the new disk logically to the Operating System by typing the following
command, specifying the correct Ap_Id label for the disk you have installed (in
this sample command the Ap_Id label is for Disk 1):
4. Confirm that the disk is now connected and configured by typing:
5. If you want to check that the disks are active, follow the instructions in
Section 10.2.1, “Using the probe-scsi Command To Confirm That Hard Disk Drives
Are Active” on page 10-8
The disk is now available to be mounted for operation.
# cfgadm -c configure c1::dsk/c1t1d0
# cfgadm -al
Ap_Id
Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 CD-ROM connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t0d0 disk connected configured unknown
c1::dsk/c1t1d0 disk connected configured unknown
c2 scsi-bus connected unconfigured unknown