Sun Microsystems Netra 120 - Manual (Page 55)

Chapter 4 Installing Optional Hardware Components 4-7
4.4 Installing and Removing a DVD or
CD-ROM Drive
Caution – Follow the instructions in this section carefully. The DVD or CD-ROM
drive contains a laser device. Do not attempt to open the DVD or CD-ROM drive’s
enclosure or remove a DVD or CD-ROM drive using any procedures other than
those contained in this section. If you do, you risk exposure to radiation.
4.4.1 Installing a DVD or CD-ROM Drive
Note – If you are going to install a full-length PCI card, install the DVD or
CD-ROM drive first. If you have a full-length PCI card already installed, you need to
remove it before installing the DVD or CD-ROM drive.
1. Remove the top cover by following the procedure described in Section 4.2,
“Opening the Server” on page 4-4.
Make sure you disconnect all power cables and wear an antistatic wrist strap.
2. Remove the front bezel.
Release it from the server by pressing in on the tabs at either end of the bezel.
3. If you have a full-length PCI card installed, you must remove it before installing
the DVD or CD-ROM drive (see Section 4.6.2, “Removing a PCI Card” on
page 4-14).
4. Squeeze and pull out the filler panel at the front of the DVD or CD-ROM
enclosure.
Class 1 Laser Product
Luokan 1 Laserlaite
Klasse 1 Laser Apparat
Laser Klasse 1
!