Sony WALKMAN WM-GX788 - Manual (Page 59)

59
To operate from the
remote control
To turn on the radio, press
RADIO ON/BAND•OFF for
more than 1 second (while the
tape is in stop mode only).
To select the band, press RADIO
ON/BAND•OFF for more than
1 second while the radio is on.
To tune in or recall a preset
station, press FF + or REW –.
To turn off the radio, press
RADIO ON/BAND•OFF.
Presetting Radio
Stations
You can preset up to 30
stations—20 for FM and 10 for
AM (for the JPn area*, up to 16
stations—8 for FM and 8 for
AM).
* Only if available. See “Receiving
Stations Outside Japan”.
Presetting Automatically
Scanned Stations
1 Press RADIO ON/BAND to
turn on the radio.
2 Press RADIO ON/BAND
repeatedly to select AM or
FM.
3 Press and hold ENTER for
more than 3 seconds.
Preset number 1 will flash in
the display and the main unit
starts scanning the stations
from the lower frequencies
and stops for about 5 seconds
when a station is received.
4 If you wish to preset the
currently received station,
press ENTER while the preset
number is flashing.
The received station is preset
on preset number 1 and the
unit starts scanning for the
next receivable station.
5 Repeat step 4 until all
receivable stations are preset.
To stop scanning
Press RADIO OFF. The radio is
turned off at the same time.
Notes
• If stations are already stored, the
newly preset stations replace the
old ones when the above
procedure is completed.
• If stations cannot be preset
automatically, preset them
manually.
Presetting Stations
Manually
1 Press RADIO ON/BAND to
turn on the radio.
2 Press RADIO ON/BAND
repeatedly to select AM or
FM.
3 Press ENTER.
The frequency digits will flash
in the display.