Sharp AR-407 - Manual (Page 166)

8-16
CHAPTER
8
KEY OPERATOR PROGRAMS
Initial Margin Shift Setting
Set the initial margin shift value with this program.
When the “INITIAL MARGIN SHIFT SETTING.” key is pressed, the
following display will appear.
1. Adjust the value for each side using the and
keys.
● The value can be set from 0 mm to 20 mm in 1 mm increments
(0" to 1" in 1/8" increments).
2. Press the “OK” key.
Erase Width Adjustment
Set the initial setting of the amount of the erase area with this program.
When the “ERASE WIDTH ADJUSTMENT.” key is pressed, the
following display will appear.
1. Adjust the values for the edge erase mode and centre
erase mode using the
and keys.
● The values can be set from 0 mm to 20 mm in 1 mm increments
(0" to 1" in 1/8" increments).
2. Press the “OK” key.
OK CANCEL
KEY OPERATOR PROGRAMS
INITIAL MARGIN SHIFT
SETTING.
SET THE INITIAL MARGIN SHIFT.
SIDE 1
(0~20)
mm
SIDE 2
(0~20)
mm 10 10
OK
KEY OPERATOR PROGRAMS
ERASE WIDTH
ADJUSTMENT.
SET THE INITIAL ERASE WIDTH.
EDGE ERASE
(0~20)
mm
CENTRE ERASE
(0~20)
mm
OK
10 10
KEY OPERATOR’S GUIDE
Key operator programs