Sharp AR-407 - Manual (Page 58)

3-24
CHAPTER
3
IMAGE EDITING FUNCTIONS
SPECIAL FUNCTIONS
Image editing functions
REPEAT COPY
REPEAT COPY is used to produce repeated images of an original on a
single sheet of paper. Border lines can be drawn to separate repeated
images.
● Up to 16 (4 x 4) copies can be made on a single sheet.
However part of the original image may not be copied, depending on the
original size, copy paper size, and the copy ratio.
● This function will not work when non-standard size paper is used.
● If the proper reduction ratio is calculated as less than 25%, part of the
original will not be copied. In that case the reduction ratio will be set to
25% showing the following message on the display. “
IMAGE DOES NOT
FIT INTO THE IMAGE AREA. COPY RATIO WILL BE SET TO 25%. ”
1 Place the originals in the document feeder tray or on the
document glass.
C
B
C
B
C
B
C
B
C
B
C
CLEAR
INTERRUPT
CA
CLEAR ALL
START
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
AUTO IMAGE
READ-END
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
A3
8 Press the START ( ) key.
● If the document feeder is used, scanning of originals and copying
will start.
● If the document glass is used in the SORT mode, proceed to the
next step.
9 Replace the finished original with the next original after
the START (
) key indicator lights up, and then press
the START ( ) key. Repeat this step until all originals
have been scanned. Then, press the “READ-END” key
on the touch panel.
● Copying will start at this time.
● Up to 120 sheets of A4 (8-1/2" x 11") originals or up to 60 sheets
of originals larger than A4 (8-1/2" x 11") can be scanned.
● To cancel the CENTRING function, press the “CENTRING” key
again on the IMAGE EDIT menu screen.