Samsung SNC-C6225 - Manual (Page 37)

English – 37
how to use osd menu
SET HOME POSITION
HOME position means the origin of PAN angle
calculation. The value of PAN angle displayed on the
screen is based on this HOME position.
By using Joystick, move the camera to the desired
position and press ENTER.
It is noted that Home is not effective to Tilt angle.
If you change the location of Home position, all horizontal
locations of functions such as preset, pattern, scan, auto
pan, and privacy zone mask will be shifted based on
changed Home position.
If there are no setup for those functions like Preset, Pattern, Auto
Pan and Scan, Camera will automatically move to Home position
after rebooting.
If Power Up Action is set to be ON, camera will continue the
function which is executed lastly after rebooting.
* Set Home Position?
When you replace the camera block or the
orientation of camera is changed due to
maintenance operations, it is very diffi cult to
maintain same pan orientation. Therefore, all
function data depending on pan orientation such
as preset, pattern, scan, auto pan, and privacy
zone mask are not useful any more accordingly.
However, even in this case, you can reuse the data
if you redefi ne Set Home Position on the previous
Home position. It is recommendable to memorize
the target scene of current Home position.
•


SET NORTH DIRECTION
You can set up North direction.
By using Joystick, move the camera to the desired
NORTH position and press ENTER key.
The direction will be displayed in the screen
[PAN AXIS / TILT AXIS / ZOOM / DD]
DD is direction and will be displayed from:
[N/NE/E/SE/S/SW/W/NW]
LANGUAGE
You can select a preferred Language of OSD display
from 7 choices.
[ENGLISH/ ESPAÑOL/ FRANÇAIS/ DEUTSCH/
ITALIANO/
РУССКИЙ/ PORTUGUÊS]
After selecting a language, press the ENTER key.
FAN RUN TEMP
Above this temperature, the blower fan will start
automatically.
[Range: 30°C ~ 80°C (86°F ~ 176°F)]
HEATER RUN TEMP
Bellow this temperature, the Heater will be tuned on
automatically.
[Range: -10°C ~ 20°C (14°F ~ 68°F)]
FAN and HEATER are only available in C7225 model.
•
•
•
•

SET HOME POSITION
MOVE TO TARGET POSITION
[ENTER : SELECT]
0/0/x1/N
SET NORTH DIRECTION
MOVE TO TARGET POSITION
[ENTER : SELECT]
0/0/x1/N
FAN/HEATER SETUP
FAN RUN TEMP 40°C
HEATER RUN TEMP 5°C
BACK
EXIT