Samsung SNC-C6225 - Manual (Page 65)

English – 65
setup tool
event is generated during the alarm output, the
delay time is recalculated on the basis of the most
recently generated an alarm.
<Alarm Image Transfer>: If <On> is selected,
a JPG image is transmitted through FTP or
Email(SMTP) or saved on the Micro SDHC memory
card according to the <EVENT>
➝ <TRANSFER
SETUP> settings.
<Camera Action>: Counteraction of camera when
Alarm Input event occurs can be selected from
<None>, <Preset 1 ~ 128>, <Pattern 1 ~ 4>,
<AutoPan 1 ~ 8>, <Scan 1 ~ 8>, <Home Position>.
MOTION
M.D. Function
Enable/Disable
Even though Motion Detection is set to be enabled,
this function is not working during PTZ, focus or Iris
operations.
For reliable performance, it takes about 1 or 2
seconds for Motion Detection to return to work after
PTZ, Focus, Iris operation.
Even if camera is subjected to external shocks or
winds, those can be considered as motion detection.
M.D. Confi guration
Set the motion detection area and the sensitivity.
Motion Sensitivity
Select a motion detection function sensitivity from
<High>, <Medium> and <Low>. The <High>
option provides high sensitivity of motion detection
and generates motion detection event if a small
motion is detected.
Motion Area
You can set an area to detect motion.
❖
•
M



❖
•
❖
•
❖
•
Activation Time
You can set time to accept a motion detection to
take an action.
<Always>: Always conducts the <Action> setting
when a motion is detected.
<Only Scheduled Time>: Conducts the <Action>
setting for a motion detection only when it occurs
during the specifi ed time period on the specifi ed
day of the week. The Start Time must prior to and
must differ from the End Time.
Action
You can set an operation to be conducted when a
motion is detected.
<Alarm Output>: Determines a motion detection
output port to which the alarm signal is to be sent.
<Output Duration>: Determines the period of time
to output the alarm signal to the specifi ed alarm
output port when a motion is detected. If another
detection event is generated during the alarm
output, the delay time is recalculated on the basis
of the most recently generated motion detection.
<Alarm Image Transfer>: If <On> is selected, a
JPG image is transmitted through FTP or Email
(SMTP) according to the <EVENT>
➝ <Transfer
Setup> settings.
❖
•
❖
•