Sony SE366 - Manual (Page 23)

23
First steps
Gigaset SE366 WLAN / englisch / A31008-M1063-R101-4x-7619 / device.fm / 13.11.2008
Sc
hablone 200
4_12
_27
Connecting to the mains power supply
ì
Connect the mains adapter cable to the 12 V DC 1A socket on the Gigaset SE366
WLAN.
ì
Plug the mains adapter into a mains socket.
Connecting PCs wirelessly via WPS
If you are using WPS (see page 13), you can connect wirelessly to other WLAN devices
quite simply via the registration button.
ì
Press the registration button for at least two seconds on the device’s back panel to
start WPS registration.
ì
Within two minutes, activate WPS registration of the wireless network adapter on
the PC. The client gets the security data for the Gigaset SE366 WLAN (SSID and
pre-shared key) and is thereby registered.
Only one client is allowed to register during a single registration phase. If the device
indicates by means of the WLAN LED that more than one client has tried to register, and
the desired client has not been registered successfully, an external device may have con-
nected to your WLAN. In this case, you should change the WPA-PSK key as quickly as pos-
Note:
Only use the mains adapter (12V DC 1A) that is supplied with the device.
WLAN LED display during WPS registration:
On (300 s)
WPS registration was successful.
Flashing slowly WPS registration is in progress.
Flashing quickly WPS registration was not successful.
Flashing quickly
with interruption More than one client tried to register.