Seiko FB-900 - Manual (Page 146)

If #40 BARCODE/ENLARGED CHAR is set to MODE 1 or MODE 2
in the EXTENDED SETUP MODE, enlarged characters can be
printed. The enlarged character function is valid for the EPSON or
IBM or HP mode.
5-16
When the enlarged character mode is selected with the DC4 DC4 I 1
command, any commands other than those shown below are ignored.
Only three print codes are available: LF, CR and FF. If 521 or more
characters of data are sent without inputting a print command, printing
is performed automatically.
Function Command
1. Executing backspacing BS
2. Executing line feeding LF
3. Executing form feeding FF
4. Executing carriage return CR
5. Initializing the enlarged character mode DC4 DC4 @
6. Arrangement of enlarged characters DC4 DC4 a
7. Element magnification for enlarged characters DC4 DC4 c
8. All-character set for enlarged characters DC4 DC4 d
9. Selecting an enlarged character font DC4 DC4 f
10. Height expansion for enlarged characters DC4 DC4 h
11. HMI for enlarged characters DC4 DC4 i
12. VMI for enlarged characters DC4 DC4 j
13. Setting and canceling the enlarged character mode DC4 DC4 l
14. Enlarged character cell offset DC4 DC4 o
15. Enlarged character pitch DC4 DC4 p
16. Enlarged character quality DC4 DC4 q
17. Enlarged character rotational angle DC4 DC4 r
18. Setting and canceling enlarged character smoothing DC4 DC4 s
19. Enlarged character top offset DC4 DC4 t
20. Setting and canceling underscores for enlarged characters DC4 DC4 u
21. Enlarged character width expansion DC4 DC4 w
22. Horizontal printing position for enlarged characters DC4 DC4 x
23. Vertical printing position for enlarged characters DC4 DC4 y
Outline of enlarged character function
Enlarged character command list
●
Enlarged character function
See page 3-36.
— 5. Bar code and enlarged character function —