Seiko FB-900 - Manual (Page 214)

●
Command
Control code
Corresponding setup function
9-14 — 9. Software setup functions —
Code Hexadecimal
HD + I + p + n (1B,7C,60,03,00,49, (47) Interface (Setup Function #70)
70,n)H
n = 0 Parallel
1 Serial
2 Auto
This setting becomes valid after the setup command
mode is terminated.
HD + I + 0 + DC0 + n (1B,7C,60,04,00,49, (48) Printer select command (Setup Function #71)
30,10,n)H
n = 0 Valid
1 Invalid
2 SLCT IN signal
This setting becomes valid after the setup command
mode is terminated.
HD + I + 1 + 0 + n (1B,7C,60,04,00,49, (49) Parity bit (SERIAL I/F) (Setup Function #72)
31,30,n)H
n = 0 None
1 Even
2 Odd
This setting becomes valid after the setup command
mode is terminated.
HD + I + 1 + 1 + n (1B,7C,60,04,00,49, (50) Data length (SERIAL I/F) (Setup Function #73)
31,31,n)H
n = 0 8 bits
1 7 bits
This setting becomes valid after the setup command
mode is terminated.
HD + I + 1 + 2 + n (1B,7C,60,04,00,49, (51) Stop bit (SERIAL I/F) (Setup Function #74)
31,32,n)H
n = 0 1 bit
1 2 bits
This setting becomes valid after the setup command
mode is terminated.
See page 3-46.
See page 3-47.
See page 3-47.
See page 3-48.
See page 3-48.