SMC Networks SMC2655W - Manual (Page 12)

7
EZ C
ONNECT
W
IRELESS
A
CCESS
P
OINT
C
ONFIGURATION
Your SMC2655W is a Plug and Play device. This
means that, in most cases, you will not need to
configure it.
The SMC2655W Access Point includes an SNMP
agent accessible through an SNMP manager
application (EZ Connect Wireless AP Manager).
The SNMP agent supports read-write and read-
only modes.
If you are adding this device into an already
existing wireless network, or if you need to
configure some advanced settings, follow the
instructions below.
The diskette labeled “Utility Diskette” that comes
with the package contains a SNMP manager
program for the EZ Connect Wireless Access
Point. Updates can be downloaded from SMC’s
Web site at http://www.smc.com.
Warning: Back up your utility diskette and use the
copy as the working diskette to protect
the original from accidental damage.
The SMC2655W can be configured over an
Ethernet network using RJ-45 cable. You may
connect the SMC2655W to a network device such
as a hub or switch. Then, run the utility program,
and configure the SMC2655W remotely as
described below.
SNMP Management Utility
Windows 98/Me/NT/2000 Installation
1. Insert the SMC2655W utility disk into the
floppy drive on your PC, and then enter the
following command: “A:\utility\setup.”
Follow the on-screen instructions to install
the utility program.