Messages – Sony Portable MD Recorder MZ-RH710 User Manual
Page 76
76
model name1[MZ-RH710] model name2[MZ------]
[2-593-568-11(2)]
masterpage:Left
filename[E:\SONY
PA\5252_RH710\REVISE\DATA\J9050645_2593568112RH710_GB\2593568112\01GB
-MZ-RH710EE\04GB0OPE.fm]
Messages
If the following messages flash in the display window, check the chart below.
Message
Meaning/Remedy
AVLS NO
VOLUME
OPERATION
• AVLS is set to “AVLS On” and so the volume cannot rise higher.
, Set AVLS to “AVLS Off” (page 55).
BLANKDISC
• A disc with no recording on it is inserted.
BUSY WAIT A
MOMENT
• The recorder is accessing disc information.
• You tried to operate the recorder while it was accessing the recorded data.
, Wait until the message goes out (in rare cases, it may take a few
minutes).
CANNOT EDIT
• You selected, “
: Set”, “
: Release”, “Move”, or “Erase” while
recording.
• You tried to erase the track mark at the beginning of the first track or
group.
• You tried to erase a track mark to combine tracks the recorder cannot
combine (a track recorded in stereo and in mono, for example).
• You tried to overwrite a track marks.
• You tried to change a title that includes characters the recorder cannot
edit.
, Editing titles cannot be done if the title includes characters that
cannot be input on the recorder.
CANNOT PLAY
• You tried to play a track that is subject to play restrictions.
• You tried to play a MP3 track which format is not supported by this
recorder.
, This recorder only supports MP3 tracks (MPEG-1 Audio Layer-3/
sampling frequency 44.1 kHz) that have been transferred using the
SonicStage software.
CANNOT
RECORD
• You tried to record on a disc that has already been recorded in MD mode.
, On this recorder, you cannot do additional recording on a disc that is
already recorded in MD mode. If you want to do additional recording
on such a disc, connect the recorder to a computer and use the
supplied software.
CANNOT
OPERATE
• You tried to press X or T MARK during synchro-recording.
CANNOT
RECORD OR
PLAY
• There is no audio data that can be played on the recorder.
• The audio data or disc management file has been damaged.
, Erase the whole disc (page 51) or perform the Format function
020REG.book Page 76 Tuesday, April 12, 2005 11:18 AM