Sanyo KH2672R - Manual (Page 17)

1
1 - 16
Care and Cleaning (continued)
4. Remove the air filter attached to the air intake grille.
1. Remove the bolt screws on the finger-hold using a screw driver. (After
cleaning, be sure to attach the two bolt screws.)
2. Take hold of the finger-hold on the air intake grille and slide it to the rear,
and the grille will open downward.
3. Take hold of the finger-hold on the air filter, first lift it and then pull it
toward you to release it from the catch.
1.
1.
Move the flap on the air outlet grille to its lowest position with the remote control unit.
2. The filter is disengaged by pushing the tab up gently. Hold the air filter by the tab
at the bottom, and pull downward.
When replacing the filter, make sure that the FRONT mark is facing you.
Push it up until you hear it click back into position.
1 Push up
then
Pull down
Wall-mounted type (K):
Latch
Bolt screw
Air intake
grille
Safety chain
Air filter
Finger-hold
Air filter
Air filter finger-hold
Catch
Air intake grille
Air filter
How to remove the filter
(continued)
How to remove the filter (continued)
Ceiling-mounted type (T):
for KHH2672R, KH3072R, KH3672R
for KH2672
2
Move the flap on the air outlet grille to its lowest position with the remote control unit.
2. The filter is disengaged by pushing the tab up gently. Hold the air filter by the tab
at the bottom, and pull downward.
When replacing the filter, make sure that the FRONT mark is facing you.
Push it up until you hear it click back into position.
Air intake grille
Air filter
06-212 PAC-i_IM_Sec1 4/12/06 7:15 PM Page 16