Sanyo KH2672R User Manual
Page 41
3
3 - 5
D: ON button
This button is for turning the selected air conditioner on.
E: OFF button
This button is for turning the selected air conditioner off.
F: Operation lamp
This lamp lights when the unit is turned on.
G: MODE button
Use this button to select one of the following five operations:
(AUTO)
: Used to automatically set cooling or heating operation.
Only for heat pump type
(temperature range: 62 ~ 80 °F)
(HEAT)
: Used for normal heating operation.
Only for heat pump type
(temperature range: 60 ~ 78 °F)
(DRY)
: Used for dehumidifying without changing the room temperature.
(temperature range: 64 ~ 86 °F)
(COOL)
: Used for normal cooling operation.
(temperature range: 64 ~ 86 °F)
(FAN)
: Used to run the fan only, without heating or cooling operation.
When the
indication is displayed, you cannot change the
mode
from and or to or and . To
change
the
mode, turn off all units once then select the mode again.
H: Temperature
: Press this button to increase the temperature setting.
setting buttons
: Press this button to decrease the temperature setting.
I: FAN SPEED button
(AUTO)
: The air conditioner automatically decides the fan speed.
(HI.)
: High fan speed.
(MED.)
: Medium fan speed.
(LO.)
: Low fan speed.
J: FLAP button
(
)
1. Use this button to set the airflow direction to a specific angle.
The airflow direction is displayed on the remote control unit.
• In the cool mode and dry mode, when the flaps are set in a
downward position, condensation may form and drip around
the vent.
• Do not move the flap with your hands.
This function is available only for models X and T.
(
)
2. Use this button to make the airflow direction sweep up and down
automatically.
Press this button several times until the (
) symbol appears on
the display.
This function is available only for models X, K and T.
1) The flap setting can be performed only for units that have no remote
controllers.
2) In the ALL or ZONE mode, no flap setting can be performed. If
necessary, you should select the GR mode and use the FLAP button.
NOTE
Operation mode
(COOL) or
(DRY)
(HEAT) or
(FAN)
(AUTO)
Cooling mode:
Heating mode:
Number of airflow direction settings
3
5
3
5
NOTE
■ Functions of buttons
(Continued)
NOTE
NOTE
NOTE
NOTE
NOTE
NOTE
05-368 PAC-i_IM_Sec3 11/24/05 6:17 PM Page 5