Sanyo KH2672R - Manual (Page 30)

2
2 - 12
Description
A: When you press the SENSOR button, the (SENSOR) indicator
appears or disappears.
B: The currently selected operation mode is displayed.
C: When setting the timer, the selected timer mode is displayed.
D: The currently selected FAN SPEED, FLAP ANGLE and SWEEP status
are displayed.
E: This indicator flashes when you operate the wireless remote controller.
Display
(Wireless Remote Controller)
A
E
B
D
C
NOTE
How to set the ADDRESS ( )
Setting addresses of indoor units for remote controller
Operation Indication
1. Press the ADDRESS button for
more than four seconds.
2. By each pressing the ADDRESS
button, the indicated address will
change from “ALL” to “1” through “6”
in turn and lap to “ALL”. Adjust the
address switch of an indoor unit you
want to operate to match its address
with the address indicated on the
remote controller.
3. Press the SET button.
• If the set address on the remote controller matches with the controller address in an indoor unit, the
buzzer will beep.
• To set the address to 1, 2, or 3, switch this “SWITCH” knob to the left;
to set the address to 4, 5, or 6, switch this “SWITCH” knob to the right.
You can set any
address in the
controller.
If the remote
controller indicates
“6”: If the remote
controller indicates
“2”: If the remote
controller indicates
“1”: If the remote
controller indicates
“ALL”: Setting of the
address switch of
the controller in an
indoor unit
Match this address with
the address indicated
on the remote
controller.
Address indication
on the remote
controller
The display of the remote
controller indicates
,
and the current address
appears and blinks.
The indicated address
stops blinking and remains
for five seconds.
SWITCH
NOTE
NOTE
05-368 PAC-i_IM_Sec2 12/7/05 4:36 PM Page 12