Sanyo KH2672R - Manual (Page 6)

1
1 - 5
O: VENTILATION
button
G: CHECK
button
Remote Cotrol Unit
• With this remote controller, you can operate indoor units up to 8 units.
• Once you set your operation conditions, you can operate the units only by pressing the ON/OFF
operation button.
• For the U type, the flap position is not shown on the display.
A: ON/OFF operation button This button is for turning the air conditioner on and off.
B: Operation lamp This lamp lights when the air conditioner is turned on.
C: MODE button Use this button to select one of the following five operations:
(AUTO) : Used to automatically set cooling or heating operation.
Only for heat pump type (temperature range: 62 ~ 80 °F)
(HEAT) : Used for normal heating operation.
Only for heat pump type (temperature range: 60 ~ 86 °F)
(DRY) : Used for dehumidifying without changing the room temperature.
(temperature range: 64 ~ 86 °F)
(COOL) : Used for normal cooling operation.
(temperature range: 64 ~ 86 °F)
(FAN) : Used to run the fan only, without heating or cooling operation.
D: Temperature : Press this button to increase the temperature setting.
setting buttons : Press this button to decrease the temperature setting.
E: FAN SPEED selector
button (AUTO) : The air conditioner automatically decides the fan speed.
(HI.) : High fan speed.
(MED.) : Medium fan speed.
(LO.) : Low fan speed.
B: OPERATION lamp
A: ON/OFF operation
button
C: MODE button
D: Temperature
setting buttons
F: FILTER reset
button
L: SET button
M: CL button
I: FLAP button
N: SENSOR
J: TIMER
SET button
K: TIME
setting
buttons
E: FAN SPEED
selector button
H: UNIT button
When low fan speed is selected and the air conditioner is in cooling
operation at a low outdoor temperature of less than 50°F, the air
conditioner may automatically switch to medium fan speed. NOTE
06-212 PAC-i_IM_Sec1 4/12/06 7:15 PM Page 5