Sanyo KH2672R - Manual (Page 23)

2
2 - 5
Unit Display and Operation Controller for K, X, and T Types (continued)
SERVICING
switches
ON/OFF operation button This button is for turning the air conditioner on and off
(automatically setting cooling or heating operation).
SWEEP button Use this button to make the airflow direction sweep up and down automatically.
Switch Usually set this switch in to the left side.
ADDRESS switch When operating the air conditioner by using the wireless remote controller, be
sure to match the number on this switch with the number set on the wireless
remote controller.
Otherwise, the remote control will not work.
SERVICING switches These switches are used only when servicing the air conditioner.
Do not use these SERVICING switches for normal operation.
Turning off the ON/OFF operation button does not
disconnect the power. Use the main power switch to turn off
the power completely.
ADDRESS
switch Switch SWEEP
button ON/OFF
operation
button
To access the operation
controller:
Press on the two latches of the air intake grille with your thumb in the direction of
the arrow to open the grille. And open the air intake grille downward. The
Operation Controller is located in front of the electrical component box.
OFF
OPER. TIMER
TEST
NORM.
STDBY
NORM. position Normal position
OFF position
Select this position when the unit will not be used
for a long period of time.
TEST position
Select this position to operate the unit continuously.
This position should not be selected under normal conditions.
05-368 PAC-i_IM_Sec2 12/7/05 4:36 PM Page 5