Sharp JW-21MN User Manual

Page 24

Advertising
background image

7-3

(6) Bending radius of the signal cable should be less than 45 mm (outside).

- Specification of the cable manufacturer is that bending radius should be 6x of the cable finish

outside diameter (approx. 7.5 mm).

(7) When you install morethan one module of the JW-21MN into one programmable controller, we

recommend to put identification tag on each dable.

(8) Before transport or store the JW-21MN, put a protection cap on the connector of the JW-21MN.

R45 or larger

Advertising