Sharp JW-21MN - Manual (Page 79)

11-26
Lower
Upper
Set the number of sending bytes in decimal on the parameter address 007720 to 007721
(8)
.
Set the number of sending bytes in decimal on the parameter address 007722 to 007723
(8)
.
Set whether the station number information should be output or not
Set whether the station number information should be output or not on the parameter address
007763
(8) .
To the next page
007763
(8)
00
(H)
: Do not output
01
(H)
: Output
The station number information is output on the next
byte of the flag area (24 bytes.)
This setting is valid when the parameter address is
007767
(8)
= 80
(H) .
007200
(8)
007721
(8)
- In case of setting 4 bytes (Example for page 11-10)
Display the contents of parameter addresses 007720 to
007721
(8)
00004 (D)
007720 (8)
007721 (8)
Screen display of JW-14PG
"Only when using save memory function"
Set the number of receiving bytes of register link in save memory function [DCM (decimal), word]
Lower
Upper
007722 (8)
007723
(8)
- In case of setting 8 bytes for parameter addresses 007722 to 007723
(8)
. (Example for page 11-10)
Display the contents of parameter addresses 007722 to
007723
(8)
00008
(D)
007722
(8)
007723
(8)
Screen display of JW-14PG
Write 00004
(D)
after converting to decimal
Write 00008
(D)
Set the number of sending bytes of the relay link in save memory function [DCM (decimal), word]
Whether the station
number information
should be output or not
V2
07714 D 00000
07716 D 00000
I PARAM.
>07720 D 00004
V2
V2
From the previous page
"Only when using save memory function"
07716 D 00000
07720 D 00000
I PARAM.
>07722 D 00008