Sharp JW-21MN - Manual (Page 78)

11-25
Turn to program mode (stop PC operation). Setting of parameters is only available when the PC is
in program mode.
Select parameter setting mode.
Write "00
(H)
" to parameter address 007777
(8)
and stop operation
of the JW-21MN. Setting of the parameter is only available
when the operation of the JW-21MN is stopped.
Connect a support tool with the JW-21MN.
<Usable support tools>
JW-14PG/13PG/12PG
JW-50SP
JW-50PG, Z-100LP2S
- For operation of each support tool, see the instruction
manual attached. The following describes an example
of JW-14PG's key operation.
Note: Setting parameters is unavailable by JW-2PG.
(JW-14JG)
JW-21MN
007777
(8)
0 0
(H)
Indications in [ ] of each item mean as follows:
(Example) Stop operation of data link [HEX (hexadecimal), byte]
This means to set "stop operation" by hexadecimal and byte unit.
Turn "ON" the power of slave station PC
Connect support tools
Stop PC operation
Stop operation of data link [HEX (hexadecimal), byte]
Stop PC operation
Select initial mode
Display the contents of parameter
address 007777 by hexadecimals.
Reference Function of JW-14PG
To the next page
Screen display of JW-14PG
07775 HEX 00
07776 HEX 1F
I PARAM.
>07777 HEX 00
Write
00
(H) .
(Set parameter)
- key: Changeover unit of figures
HEX (hexadecimal) OCT (octal) DCM (decimal) Bit pattern
- key: Byte display Changeover word display