Solid State Logic Duality 82S6DUA20C - Manual (Page 101)

C Cr re ea at ti in ng g A A N Ne ew w M Mi ix x P Pa as ss s
To create a new automated Mix Pass, press List Mix to access the screen shown below, use the lefthand
encoder to highlight the New Mix entry.
Now press the encoder switch to select the New
Mix Setup page (see below). All the channel faders
will enter Absolute mode, as indicated by a red
LED next to each fader.
The DAW should be positioned a few frames earlier than the required starting point, to allow the mix system to
lock to the incoming timecode.
The current automation status for each channel is displayed in the scribble strip above the fader, replacing the
standard ‘Fader ##’ label. Faders can be toggled between Absolute and Manual using the fader status button
located next to the fader, or globally using the FSM (Fader Status Master) soft key (see below).
New Mix Pass modes for faders
Absolute mode: Red LED. All automated moves
are written at the current fader position.
Manual mode: No LEDs. The fader operates as a
monitor fader only, ie. no information will be written
to memory.
Pressing the CANCEL button (in the ‘AUTOMATION’ group above the ‘TRANSPORT’ buttons) will return you to
the List Mix page. See Dedicated Automation Buttons for more information.
Mix Enabled
Misc
Moff
TR
TLock Trim Snap AT
SSL
Execute FSM
Auto
CS
***NEW MIX***
you may adjust status now.
Press Execute to continue
Cancel
Lnks
Project 16 :: Title 1
Misc
Trim Moff TLock Snap AT
Proj TR Lnks Misc
Select Delete
Project 16 :: Title 1
CS
Auto SSL
NEW MIX
Mix Enabled
Duality Operator’s Manual 5 5 - - 5 5
Creating a New Mix pass