Solid State Logic Duality 82S6DUA20C - Manual (Page 96)

Resetting soft switches
A double press on a fader status button, or Set Sel or Set All, will reset all the non-latching functions on that
channel strip, selected channel strips, or all channel strips respectively. The non-latching functions are:
• Input section buttons
• Dynamics assignment and routing buttons
• EQ and Insert buttons
• Aux on/off and EFX reassign buttons
• Main and Track bus routing
• Fader position
All latching switches must be reset manually.
Copying and Swapping settings between channels
Stored TR Setups can be copied or swapped between channels by holding down the fader status button on the
source channel then pressing the fader status button on the destination channel. If the COPY soft key is
selected, source channel settings are copied to the destination channel; if not, the source and destination
channel settings are swapped.
Copying TR Setups to a DAW Folder
TR setups stored in Duality’s flash memory may be copied to or from a folder on your Mac or PC using the
Duality Remote application. Please refer to the Duality support pages at http://www.solid-state-logic.com for
more details.
Total Recall
4 - 6 Duality Operator’s Manual