Solid State Logic Duality 82S6DUA20C - Manual (Page 27)

The Centre Section
Introduction
The console’s centre section (see opposite) comprises four main areas:
Centre section meter panel.
Audio master control functions.
TFT screen and panels dedicated to DAW control; automation controls; DAW transport controls.
Group faders and master fader. To the right of this area is a trackball for DAW control.
Once you have spent a few moments sitting at the console, you will find the Duality’s centre section layout just
as intuitive as its channel strip.
The following pages cover all the analogue controls in the centre section. See Section 3 for details of the
console’s DAW control facilities.
Power Supply Indicators
Before we cover the more interesting features of the centre section, take a moment to acquaint yourself with
the console’s power supply indicators. If you suspect a hardware problem, and one of the LEDs described
below is not lit, there may be a power supply fault. The LEDs, which display the current state of power rails
within the console, are in the top left hand corner of the centre section, above the oscillator and talkback level
controls.
The ±15 Volt and the +4 Volt supplies are for analogue audio and logic circuitry respectively. The +12 Volt
supply provides power for the faders and some relays. All LEDs should normally be illuminated, if not – try not
to panic!
4
3
2
1
Centre Section
2 - 1 5 Duality Operator’s Manual