Solid State Logic Duality 82S6DUA20C - Manual (Page 110)

C Co op py y a an nd d S Sw wa ap p
Copy and Swap (CS in the Auto menu) are used to interchange or transfer mix data between channels. The
required function is selected by pressing the CS soft key to toggle between the two modes.
Copy is displayed as Cpy, Swap as Swp. Select the function required, hold down the source channel fader
button while you press the destination channel fader button. While the fader buttons are active, ‘src’ and ‘dest’
will be displayed in the scribble strip above each fader. Note that you can only Copy or Swap automation data
when the system is in Mix Running or Mix Review.
The Copy function copies data to a single channel only. To copy the same data to multiple channels, repeat the
Copy operation as many times as required.
The mix data generated by a Copy or Swap is not saved until the current Mix Pass is ‘Ended’.
Glide Frames — Sets the ramp time in frames for Snap mode. The range is from 0 (no glide) to 255 (10
second glide).
Rollback Threshold frames — Sets the number of consecutive, decrementing, frames that the systems needs
to see to determine if a rollback has taken place. The range is 2-10; the default is 2 frames. Increase as
required if a rollback occurs when you stop the timecode master.
Automation
5 5 - - 1 1 4 4 Duality Operator’s Manual