Solid State Logic Duality 82S6DUA20C - Manual (Page 66)

DAW Control GuidE
3 - 1 6 Duality Operator’s Manual
Notes on Scrub and Shuttle Modes
The position at which the scrub/shuttle starts is derived from the current DAW selection or timeline position.
Scrub/Shuttle mode can commence from the selection end point by holding down the OPTION button before you
grab the shuttle wheel.
Holding down the ALT button will increase the resolution of the scrub/shuttle wheel.
When scrub or shuttle is active, many functions are suspended until you exit from scrub/shuttle mode. The
following functions are available:
Fader control, solo and cut buttons
Scrub/Shuttle wheel functions
Transport controls
Enter button (to create marker/cue events)
Scrub/Shuttle will also control serial machines if the DAW is 9-pin enabled.
Numeric Keypad (18)
The console’s numeric keypad replicates the numeric keypad on a DAW keyboard. The primary use for this
keypad is for saving and recalling Memory Locates and entering data values (please refer to your DAW manual
for more details on keypad uses).
Working with Markers/Memory Locations
To Enter a Marker/Cue point, press ENTER. To Recall a Marker/Cue point, press a number followed by the
decimal point button (Numeric Keypad in Classic mode) or a decimal point followed by a number followed a
decimal point (Numeric Keypad in Transport mode).
The ENTER button on the keypad also works as a enter button for pop-up windows,
duplicating the ENTER button on the Master Control Panel