Fuse replacement, Using cigarette lighter adaptor – Sanyo DVD-L70 User Manual

Page 13

Advertising
background image

-E13-

Caution on the cigarette lighter adaptor:
• Use this unit only with the supplied cigarette lighter

adaptor. Use with other cigarette lighter adaptors
could damage the unit.

• When the inside of the cigarette lighter socket is

dirty with ashes or dust, the plug section may
become hot due to poor contact. Be sure to clean
the cigarette lighter socket before use.

• After use, disconnect the cigarette lighter adaptor

plugs from both this unit and the cigarette lighter
socket.

• The cigarette lighter adaptor may cause interference

with reception from the car radio or another radio
inside the vehicle or the boat. If this is the case,
disconnect the cigarette lighter adaptor from the
cigarette lighter socket, or use the radio at a distance
from the cigarette lighter adaptor.

Fuse Replacement

When the cigarette lighter adaptor does not operate, check to see if the fuse has blown. If the fuse has blown,
try to determine the cause, then replace the fuse according to the following procedure.

1. Disconnect the cigarette lighter plug from the cigarette lighter socket.
2. Turn the end portion of the plug and remove.
3. Remove the blown fuse.
4. Put in a new 8A fuse.
5. Turn the end portion of the plug and tighten.

Notes:
• Replace the fuse with one of the same rating.
• If the fuse blows again after replacement, contact

the store where you purchased the unit, or contact
a Sanyo Authorized Service Station.

Traffic safety:
• Do not use while operating a motorized vehicle or boat. It may create a traffic hazart and is illegal in many

areas.

• You should use extreme caution or temporarily discontinue use in potentially hazardous situations.

CAUTION:
The unit’s cabinet may warp or the unit may otherwise be damaged if it is placed in direct sunlight, near heaters
or in cars with the windows closed.

DC IN 12V-13.5V

Fuse

Cigarette lighter plug

End of the plug

Remove

Tighten

• The supplied cigarette lighter adaptor is designed for use with vehicles or boats that have a 12V, negative

ground electrical system.

• Most vehicles or boats have this type of electrical system, but if you are unsure about the type your vehicle

or boat has, contact the vehicle or the boat dealer.

Using Cigarette Lighter Adaptor

Plug one end of the cigarette lighter adaptor into the DC IN 12V-13.5V jack, then plug the other end into the
cigarette lighter socket.

Cigarette lighter adappr (supplied)

5D90401A P07-13

26/06/2003, 16:52

13

Advertising