Sony BKP-7933 - Manual (Page 36)

1-30 (E)
BKP-7933
Setting from the S-BUS Primary Station
1. Select the menu item “Z:BKP-7933 CONFIGURA-
TION” and press [ENTER].
SONY ROUTING SYSTEM SETUP MENU BKP-7933 V1.00 STATION NUMBER 2
MODIFICATION COMMAND
A: SET UNIT LOCATION(CAM-CCU) B: SET UNIT LOCATION(CCU-RCP)
C: SET UNIT LOCATION(MSU)
K: RESET TO DEFAULT TABLE
MAINTENANCE COMMAND
Z: BKP-7933 CONFIGURATION
Ctrl-D RETURN
BKP-7933 CONFIGURATION BKP-7933 V1.00 STATION NUMBER 2
S-BUS CONFIGURATION
A: ROUTER PIX1 ASSIGN B: ROUTER WF1 ASSIGN
C: ROUTER PIX2 ASSIGN D: ROUTER WF2 ASSIGN
E: ROUTER PIX3 ASSIGN F: ROUTER WF3 ASSIGN
G: S-BUS TALLY H: BKP-7933 MODE
Ctrl-E RETURN TO MENU
2. Select “G: S-BUS TALLY” using the cursor key and
press [ENTER].
3. Move the cursor key to the desired position to be
changed and press [ENTER]. (The display enters the
input mode.)
4. Input the SOURCE No. using the numeric keys and
press [ENTER]. At this time, assign the SOURCE
No. that has already been set by the system, to the
camera number.
m
. Any number in the range of 1 to 512 can be set.
. Up to four group tallies can be set.
. The installation shows the display on which the tally
signal of the SOURCE No. 0001 is assigned to the
Camera No.1.
1-7. Setting Up
BKP-7933 CONFIGURATION BKP-7933 V1.00 STATION NUMBER 2
SBUS TALLY SOURCE
CNU GROUP No SOURCE No
(Camera No.)
0 ( 1) 1_0001 2_0000 3_0000 4_0000
0 ( 2) 1_0002 2_0000 3_0000 4_0000
0 ( 3) 1_0003 2_0000 3_0000 4_0000
0 ( 4) 1_0000 2_0000 3_0000 4_0000
0 ( 5) 1_0000 2_0000 3_0000 4_0000
0 ( 6) 1_0000 2_0000 3_0000 4_0000
1 ( 7) 1_0000 2_0000 3_0000 4_0000
1 ( 8) 1_0000 2_0000 3_0000 4_0000
1 ( 9) 1_0000 2_0000 3_0000 4_0000
1 (10) 1_0000 2_0000 3_0000 4_0000
1 (11) 1_0000 2_0000 3_0000 4_0000
1 (12) 1_0000 2_0000 3_0000 4_0000
F1:F2: F3:PgUp F4:PgDn Ctrl-E RETURN TO MENU