Sony CDP-D500 - Manual (Page 12)

Playing CDs
12 EN
You can check how a track will affect the total
playing time of the program (Program Edit)
To select a track, turn the JOG dial or press =/+
and check the total playing time. Then press PROGRAM
to confirm your selection.
The program remains even after the Program Play
ends
When you press the ( button, you can play the same
program again.
Notes
• “– – . – –” appears instead of the total playing time in the
display when it exceeds 100 minutes.
• “PGM FULL” appears in the display when you try to add a
track to a program which already contains 24 tracks.
Checking the track order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
track number in the programmed order. After the last
track in the program, the display shows “- END -” and
returns to the original display. If you check the order
after you start playing, the display shows only the
remaining track numbers.
Changing the track order
You can change your program before you start playing.
To
Erase a track
Erase the last track in the
program
Add tracks to the end of the
program
Change the whole program
completely
Fading In or Out
You can manually fade the sound in or out to prevent
tracks from starting or ending abruptly.
Note that you cannot use this effect when you use the
DIGITAL OUT jack or connector.
Press FADER
During pause. The FADE indication
flashes and play fades in.
When you want to start fading out.
The
FADE indication flashes. The
play fades out and the player
pauses.
You can fade in or out by remote control
Connect a fader start system to the REMOTE (8P)
connector on the rear panel of the player (see
“Connecting a fader start system” on page 7).
Changing the fading time
You can change the fading time from 1 to 9 seconds
before fading in or out. The fading time is factory set to
5 seconds.
1
Press FADER before you start playing.
2
Press 0/) or turn the JOG dial to specify the
fading time.
To
Start play fading in
End play fading out
JOG dial FADER 0/)
Press
CHECK until the track you
don’t want appears in the
display, then press CLEAR
CLEAR. Each time you press
the button, the last track will
be cleared.
Number buttons of the tracks
to be added
p (stop). Create a new
program following the
programming procedure.