Troubleshooting, Specifications, Additional information – Sony CDP-D500 User Manual

Page 20

Advertising
background image

Additional Information

20

EN

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.

There’s no sound.

/Check that the player is connected securely.
/Make sure you operate the connected

component correctly.

/Adjust the playback level using the PHONE

LEVEL control.

The CD does not play.

/There’s no CD inside the player (“-NO DISC-”

appears). Insert a CD.

/Place the CD with the label side up on the disc

tray correctly.

/Clean the CD (see page 19).
/Moisture has condensed inside the player.

Remove the disc and leave the player turned on
for about an hour (see page 19).

The remote commander does not function.

/Remove the obstacles in the path of the remote

commander and the player.

/Point the remote commander at the remote

sensor in the left of the display on the player.

/Replace all the batteries in the remote

commander with new ones if they are weak.

/Set the Remote Protect of menu options to “RM

ENABLE” (see page 18).

The controls on the player do not function.

/Set the Key Protect of menu options to “LOCAL

ON” (see page 18).

The player functions incorrectly.

/The microcomputer chips may be operating

incorrectly. Turn off the player and turn it on
again.

Specifications

Compact disc player

Frequency response

5 Hz to 20 kHz ± 0.3 dB (at 10 kilohms)

Signal-to-noise ratio

More than 100 dB (20 kHz LPF, IHF-A
weight)

Dynamic range

More than 98 dB

Harmonic distortion

Less than 0.004% (1 kHz, 0 dB, 20 kHz
LPF)

Channel separation

More than 100 dB (1 kHz, 20 kHz LPF)

Analog outputs

Connector

ANALOG OUT
(BALANCE)

ANALOG OUT
(UNBALANCE)

PHONES

Digital outputs

Connector

DIGITAL OUT
(AES/EBU)

DIGITAL OUT
(IEC-958)

Word input

Connector

EXT SYNC
INPUT

Type

XLR-3

Phono
jacks

Stereo
phone jack

Output
impedance

100 ohms

200 ohms

150 ohms

Maximum
output level

+24 dBs

+ 9 dBs

15 mW

Load
impedance

More than
10 kilohms

More than
10 kilohms

32 ohms

Type

XLR-3

Phono jacks

Load
impedance

110 ohms

75 ohms

Output
impedance

50 ohms
(balanced)

75 ohms
(unbalanced)

Type

BNC

Input level

2 V p-p
(TTL
level)

Input
frequency

44.1 kH
±12.5%

Input
impedance

22 kilohms/
75 ohms,
switchable

Advertising