Sony ShowView SLV-SE510B - Manual (Page 47)

47 Recording TV programmes using the Dial Timer
Bas
ic
O
pe
ration
s
Master Page : Right
filename[010bas.fm] model name1[SLV-SE510B] [3-065-671-E1 (1) GB]
To return to the previous step
To return to the previous step, press the CHAINE + and – buttons on the
VCR at the same time during any of the Dial Timer settings.
To stop recording
To stop the VCR while recording, press x STOP.
To use the VCR after setting the timer
To use the VCR before a recording begins, just press ?/1. The indicator
turns off and the VCR switches on. Remember to press ?/1 to reset the VCR
to recording standby after using the VCR.
You can also do the following tasks while the VCR is recording:
• Reset the counter (page 41).
• Display tape information on the TV screen (page 43).
• Check the timer settings (page 61).
• Watch another TV programme (page 43).
7 Press PROG.
The programme position or station name appears in the display
window.
8 Turn PROG to set the programme position.
To record from a decoder or other source connected to the LIGNE-1
(TV) or ENTREE LIGNE-2 connector, turn
PROG or press
CHOIX ENTREE to display “L1” or “L2” in the display window.
9 Press PROG to complete the setting.
“OK” appears in the display window for about five seconds.
The indicator appears in the display window and the VCR stands
by for recording.
To record from a decoder or other source, leave the connected
equipment switched on.
PROG
SP
OPC MAGN
AP
TO
PROG
CHOIX
ENTREE
SP
OPC MAGN
PROG
continued