Sony ShowView SLV-SE510B - Manual (Page 75)

75 Troubleshooting
A
d
d
ition
al
In
fo
rm
atio
n
Master Page : Right
filename[010ADDI.fm] model name1[SLV-SE510B] [3-065-671-E1 (1) GB]
Tim
e
r
rec
or
d
ing
The VPS/PDC function
does not operate
properly. • Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one
(there might be a mistake in the TV programme guide). If
the broadcast you wanted to record did not send the good
VPS/PDC information, the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be
altered and the VCR might not start recording.
Sy
nc
hr
onize
d
R
ec
or
di
ng
The ENR SYNCHRO
button turns off while
recording or does not go
back to recording
standby mode. • The tape has reached its end. Insert a new tape and press
ENR SYNCHRO again.
The Synchronized
Recording function does
not work. • The connected equipment was not turned off. Turn off the
connected equipment and press ENR SYNCHRO again.
• There was a power failure. Press ENR SYNCHRO again.
The programme recorded
with the Synchronized
Recording function is
incomplete. • If the settings for timer recordings and Synchronized
Recording overlap, the programme that starts first has
priority and the second programme starts recording only
after the first programme has finished.
• There was a power failure. Press ENR SYNCHRO again.
Ca
n
a
l
P
lu
s
You cannot set the
channel as Canal Plus in
the REGLAGE DES
CHAINES menu. • Check that DECODEUR/LIGNE2 in the OPTIONS-2
menu is set to DECODEUR (see page 70).
You cannot watch the
Canal Plus programme
when the VCR is in
standby mode. • Check that DECODEUR/LIGNE2 in the OPTIONS-2
menu is set to DECODEUR (see page 70).
• Make sure the Canal Plus PERITEL cable is plugged
securely.
The Canal Plus
programme is always
recorded scrambled. • Make sure the Canal Plus PERITEL cable is plugged
securely.
• Check that DECODEUR/LIGNE2 in the OPTIONS-2
menu is set to DECODEUR (see page 70).
• Check that this channel is set as Canal Plus in the
REGLAGE DES CHAINES menu (see page 36).
Oth
e
rs
A tape cannot be inserted. • Check that a tape isn’t already in the tape compartment.
The remote commander
does not function. • Make sure you are pointing the remote commander at the
remote sensor on the VCR.
• Replace all the batteries in the remote commander with
new ones if they are weak.
• Make sure the [TV] / [MAGN] remote control switch is set
correctly.
“L2” does not appear in
the display window. • Check that DECODEUR/LIGNE2 in the OPTIONS-2
menu is set to LIGNE2 (see page 70).
Symptom Remedy
continued