Now you can operate your vcr, Quick start guide – Sony ShowView SLV-SE510B User Manual
Page 80
Sony Corporation
Quick Start Guide
1
Connecting the VCR
1
... Connect the aerial to ANTENNE ENTREE of the
VCR.
2
... Connect ANTENNE SORTIE the aerial input
of your TV using the supplied aerial cable.
3
... For better picture and sound, connect LIGNE-1
(TV) to your TV using a PERITEL cable if your
TV has a PERITEL connector.
4
... Connect the mains lead to the mains.
2
Tuning your TV to the VCR
A
If your TV does not have a PERITEL connector
1
... P
ress
I
/1 (marche/veille) to turn on the VCR.
2
... Press REGL CANAL on the VCR lightly.
3
... Turn on your TV and select a programme
position for the VCR picture.
4
... Press REGL CANAL.
5
... Press CHAINE +/– to select the TV system
(“G” for B/G, “L” for L).
6
... Tune the TV to the same channel shown in
the VCR display window so that
MAGNETOSOPE SONY appears clearly on
the TV screen. Refer to your TV’s instruction
manual for tuning instructions.
7
... Press REGL CANAL.
B
If your TV has a PERITEL connector
1
... P
ress
I
/1 (marche/veille) to turn on the VCR.
2
... Press REGL CANAL on the VCR lightly.
3
... Press CHAINE +/– to set the RF channel to
OFF.
4
... Press REGL CANAL.
3
Using the Auto Set Up function
You can preset channels
Hold down REGLAGE AUTO for three seconds.
When all the receivable channels are preset,
“SET UP” disappears from the display window.
You can rearrange the programme position to
your favourite order (see “Changing/disabling
programme positions”).
Note
• The Auto Set Up function may require a
long time to complete (approximately 15
to 18 minutes).
Now you can operate your VCR.
1
2
3
4
ANTENNE
SORTIE
ANTENNE ENTREE
l
: Signal flow
y
LIGNE-1 (TV)
I
/1
REGL CANAL
CHAINE +/–
REGLAGE AUTO