Sony ShowView SLV-SE510B - Manual (Page 72)

72 Editing with another VCR
Master Page : Left
filename[010addo.fm] model name1[SLV-SE510B] [3-065-671-E1 (1) GB]
Notes
• If you connect this VCR to both the ENTREE LIGNE and SORTIE LIGNE jacks
of the other VCR, select the input correctly to prevent a humming noise.
• If the other VCR does not have a PERITEL connector, use the VMC-2106HG
cable instead and connect the cable to the line out jacks of the other VCR.
• When you connect another VCR to the DECODEUR/ENTREE LIGNE-2
connector, set DECODEUR/LIGNE2 to LIGNE2 in the OPTIONS-2 menu.
Operation (when recording on this VCR)
Before you start editing
• Turn on your TV and set it to the
video channel.
• Press CHOIX ENTREE to display
“L1” or “L2” in the display
window.
• Press SP/LP to select the tape
speed, SP or LP.
To stop editing
Press the x (stop) buttons on both VCRs.
Tip
• To cut out unwanted scenes while editing, press X (pause) on this VCR when an
unwanted scene begins. When it ends, press X (pause) again to resume recording.
Note
• If you start editing following the procedure above, the VCR won’t start recording
with the OPC function. To record a tape with the OPC function, press z ENR
again during recording pause in step 3 so the VCR analyses the tape. Then, press
X (pause) after the OPC indicator stops flashing to start recording. If you press X
(pause) before the OPC indicator stops flashing, the OPC function is cancelled.
1 Insert a source tape with its safety tab removed into the other (playback)
VCR. Search for the point to start playback and set it to playback pause.
2 Insert a tape with its safety tab in place into this (recording) VCR.
Search for the point to start recording and press X (pause).
3 Press z ENR on this VCR to set it to recording pause.
4 To start editing, press the X (pause) buttons on both VCRs at the same
time.
X
z ENR