Star Micronics DOT MATRIX PRINTER SP2000 - Manual (Page 35)

33
1-2-6. Auto Cutter Control (SP2500 type printers only)
FUNCTION Full-cut command to the auto cutter
CODE <ESC> "d" "0" or <ESC> "d" <0>
(1B)H (64)H (30)H or (1B)H (64)H (00)H
OUTLINE Full cut command. Executes a full cut after printing the data in
the line buffer.
This command is valid only on SP2520/SP2560 series printers
and is ignored on SP2320/SP2360 series printers.
FUNCTION Partial-cut command to the auto cutter
CODE <ESC> "d" "1" or <ESC> "d" <1>
(1B)H (64)H (31)H or (1B)H (64)H (01)H
OUTLINE Partial cut command. Executes a partial cut after printing the
data in the line buffer.
This command is valid only on SP2520/SP2560 series printers
and is ignored on SP2320/SP2360 Õeries printers.
FUNCTION Full-cut command to the auto cutter after paper feed
CODE <ESC> “d” “2” or <ESC> “d” <2>
(1B)H (64)H (32)H or (1B)H (64)H (02)H
OUTLINE Paper feed + full cut command
Executes the following actions after printing the data in the line
buffer.
(SP2520/2560) Feeds paper to the cutting position and executes
a full cut (Note 1).
(SP2320/2360) Feeds paper to the tear bar position (Note 2).
Note 1: Paper feed to cut position: Executed in 1 inch units.
Note 2: Paper feed to tear bar position: Executed in 7/6 inch
units.