Star Micronics DOT MATRIX PRINTER SP2000 - Manual (Page 44)

42
N = 4 (ESC/POS mode)
n3: Always “0”
Para. Setting “0” “1” “2” “3”
n1 RTS signal condition Save as Save as Always Always
DTR DTR SPACE SPACE
n2 Receive buffer size 4 k bytes 4 k bytes 40 bytes 40 bytes
n3 DSR signal check Checked Checked Not Not
during setting status Checked Checked
transmission
6) N = 5
n1: Always “0”
n2: Always “0”
n3: Always “0”
n4: Always “0”
7) N = 6
n3: Always “0”
n4: Always “0”
Para. Setting “0” to “F”
n1 Device ID (Parallel I/F only)
nPError signal (Parallel I/F only)
n2 Busy condition (Star mode only) *1 See below
Treatment of missing data
during reverse mode.*2
n1 Device ID
“0” or “2” or “4” or “6” or “8” or “A” or “C” or “E” Invalid
“1” or “3” or “5” or “7” or “9” or “B” or “D” or “F” Valid
n1 nPError signal
“0” to “7” Paper end sensor
“8” to “F” Paper end sensor and+ Paper near end sensor
n2 Busy condition
“0” or “2” or “4” or “6” or “8” or “A” or “C” or “E”
Receive buffer
full or offline
“1” or “3” or “5” or “7” or “9” or “B” or “D” or “F”
Receive buffer
full