Sony XDCAM HD PDW-HD1500 - Manual (Page 27)

27
Initial Setup
Chapt
er
3
Pre
par
at
ion
s
3
Slide the BP-GL95 as shown below so that the
connectors on the BP-GL95 and the BKP-L551 are
connected.
4
Connect the DC cable of the BKP-L551 to the DC IN
12V connector.
Removing the battery pack
With the lever pushed in, slide the BP-GL95 out as shown
below.
Checking the remaining battery power
You can use the LEDs on the side panel of the battery to
check the remaining power of the battery.
Initial Setup
This unit is shipped with the area of use, system frequency,
recording format, and current date and time still unset.
Therefore, you need to make initial setup settings before
using the unit. (You cannot use the unit without setting it
up.)
Once the unit has been set up, the settings are retained even
when the unit is powered off.
Use the following procedures.
1
Power the unit on.
The INITIAL SETUP screen appears on the display.
2
Turn the PUSH SET(S.SEL) knob to select the area of
use.
Display UC (for regions outside Japan) or J (for
Japan), and then press the SET function button (F5).
The system frequency screen appears.
3
Turn the PUSH SET(S.SEL) knob to select the system
frequency.
BP-GL95
Lever
REC NET
REMOTE LOCAL
VARIABLE KEY INHI
PRE- SET ON
OFF PB
PHONES LEVEL
SHIFT
DISPLAY
HOME
PAGE
EXPAND
CHAPTER
TOP F REV F FWD END STANDBY REC INHI
PREV NEXT PLAY STOP REC THUMBNAIL
RETURN
PUSH SET(S.SEL)
MENU
RESET
MARK2
MARK1
IN OUT
SHTL/JOG
SUB CLIP
DISC MENU
VAR/JOG
EJECT
ACCESS
CH-1
ALL CH
CH-2
CH-3
CH-4
POWER AC IN
1
5 5,6 2,3,4
RETURN
SET
INIT
INITIAL SETUP
UC/J MODEL
SELECT
NONE
INC/DEC : CTRL.KNOB
CANCEL&PREV : F1(RET)
SET&NEXT : F5(SET)