Sharp AR-C260 - Manual (Page 54)

SADDLE STITCH FINISHER
3-6
Using the saddle stitch finisher
Touch the [Output] key on the main screen of copy mode to display the screen that allows selection of sort, staple
sort, centerline stapling, group function, and the output tray.
[GROUP] key (See page 3-4.)
When Group is selected, all copies of the same
original will be grouped.
[STAPLE SORT] key (See page 3-4.)
When Staple Sort is selected, sorted sets will be
stapled and delivered to the offset tray. (They will
not be offset stacked.)
[SORT] key (See page 3-4.)
When Sort is selected, sets of copies will be
sequentially delivered.
[FINISHER TRAY] key
When the offset function is selected, output goes to
the offset tray. (The offset tray is automatically
selected when the staple sort function is turned
on.)
[OFFSET] key (See page 3-4.)
The offset function operates when "Yes" is
selected, and doesn't operate when "No" is
selected. (The offset checkmark is automatically
cleared when the staple sort function is turned on.)
[CENTER TRAY] key
If the center tray is selected, output paper will be
delivered to the exit tray located above the main
unit.
[OK] key
Touch to close the [OUTPUT] screen and to return
to the main screen.
[SADDLE STITCH] key (See page 3-5.)
When saddle stitching is selected, the copies will
be stapled at the center and delivered to the saddle
stitch tray.
Touch this key to display the pamphlet copy setting
screen (page 6-25). (This is only possible when a
checkmark appears in the checkbox of the
[AUTOMATIC SADDLE STITCH] key operator
program (see page 10 of the Key operator's
guide.))
[PUNCH] key (See page 3-5.)
If the saddle stitch finisher is equipped with a hole
punch module, printed paper can be hole punched
and delivered to the offset tray.
* When one of the functions is selected, it is
highlighted.
OUTPUT OK
SADDLE
STITCH PUNCH
FINISHER
TRAY
CENTER
TRAY
STAPLE
SORT
SORT
GROUP
OFFSET
00-08.book 6 ページ ２００２年１１月８日 金曜日 午前９時３９分