Sony STR-DA4ES - Manual (Page 47)

Advanced adjustments and settings
47 GB
Advanced settings
Using the CUSTOMIZE menu
to adjust the receiver
You can adjust various receiver settings using
the CUSTOMIZE menu.
1
Press CUSTOMIZE.
The CUSTOMIZE button lights up and the
CUSTOMIZE menu appears in the display.
2
Press the cursor buttons ( or ) to
select the parameter.
For details, see “CUSTOM menu
parameters” below.
3
Turn the jog dial to adjust the selected
parameter.
4
Repeat steps 2 and 3 to adjust the other
items.
CUSTOM menu parameters
The initial setting is underlined.
x MENU EXPAND (Menu expanding)
• ON
The advanced parameters for the SET UP,
SURROUND, LEVEL, and EQ menus are
displayed and can be adjusted.
For details on each setup items, see pages 21, 43–45
and the following pages.
• OFF
The advanced parameters are not displayed.
x dts 96/24DEC.
(DTS 96/24 decoding mode)
• AUTO
When a DTS 96/24 signal is input, it is played back
at 96 kHz sampling frequencies.
• OFF
Even when a DTS 96/24 signal is input, it is played
back at 48 kHz sampling frequencies.
Note
This parameter is valid only in the AUTO
DECODING mode (page 34). In other sound fields,
this parameter is always set to “OFF”.
x 2CH MODE
(2 channel decoding mode)
You can use the CUSTOMIZE menu to set the 2
channel decoding mode (page 38).
You can set this parameter only when NORMAL
SURROUND or AUTO DECODING* is selected. In
the Cinema Studio EX mode, this parameter is always
set to “PRO LOGIC” and cannot be changed.
For details on each decoding mode, see page 38.
* The selected decoding mode is applied only when
the Dolby Digital [Lt/Rt] signal is input.
• PRO LOGIC
• PLII MOVIE
• PLII MUSIC
• Neo: Cinema
• Neo: Music
x SB DECODING
(Surround back decoding mode)
You can use the CUSTOMIZE menu to set the
surround back decoding mode (page 39).
For details on each decoding mode, see page 39.
• AUTO
• MATRIX
• OFF
x MULTI CH 1
(Multi channel 1 assignment)
x MULTI CH 2
(Multi channel 2 assignment)
Initial setting: NONE (no assignment)
Lets you assign the audio signal input to MULTI CH
IN 1 (or 2) jacks to any function except TUNER and
PHONO.
You cannot assign both “MULTI CH 1” and “MULTI
CH 2” to the same function.
x D.POWER (Digital power management)
• AUTO OFF
Lets you turn off the power of the unnecessary
digital circuits automatically when outputting the
analog audio signals using the ANALOG DIRECT
or MULTI CH DIRECT function. You can enjoy
high quality analog audio without the influence of
digital circuits.
• ALWAYS ON
Lets you keep the power of digital circuits on.
Select if you do not like the time lag that occurs
with the “AUTO OFF” setting when digital circuits
are turned on, etc.
continued