Sony STR-DA4ES - Manual (Page 72)

72 GB
Changing button assignments
You can change the factory settings of the
function buttons to suit the components in your
system. For example, if you connect a LD
player to the VIDEO 2 jacks on the receiver,
you can set the VIDEO2 button on this remote
to control the LD player.
Note, however, that the settings of the TUNER
button cannot be changed.
1
Press USE MODE for more than 2
seconds.
The indicator remains lit.
2
Press the function button you want to
change the assignment of.
The indicator turns off when a valid button
is pressed. Only the first function button
that is pressed will be registered.
Example: Press VIDEO2.
3
Press the function button whose
assignment you want to change.
See the table below for the factory assigned
categories of each button. To select “2nd
pressed” or “3rd pressed” categories, press
the same button twice or three times. The
indicator turns off when a valid button is
pressed.
Example: Press DVD/LD twice.
4
Press SOURCE.
The new assignment is registered.
The indicator slowly lights up twice, then
goes off.
Tip
If the operation is unsuccessful, the indicator flashes
twice and the remote automatically exits the button
assignment mode. In this case, the new assignment is
not registered and the previous setting remains.
qd USE MODE button
Press to change the mode of the remote or
to change the category of the buttons.
qf USE MODE indicator
* The function of these buttons switches
automatically each time you press the function
buttons (3). The above explanation is intended to
serve as an example only. Therefore, depending on
the component, the above operation may not be
possible or may operate differently than described.
Tip
To clear all programmed signals, press ?/1 and USE
MODE at the same time. The remote is reset to its
factory-setting.
Listening to the sound in another
room (continued)