Samson StudioDock 3i - Manual (Page 17)

11
Figure 10
Figure 9
Figure 11
Getting Started with Windows XP
The StudioDock does not require any
special drivers or software. Just plug in
the StudioDock into a USB port on your
computer and everything is installed
automatically.
1. The first time you plug the StudioDock
into a USB port, Windows XP will
install the universal drivers for that
port. A balloon tip will pop up, telling
you it has found the USB Audio codec
(figure 9).
2. When it is finished installing the
drivers, it will say “Your new hardware
is installed and ready to use” (figure
10).
Note: This balloon will not pop up
again for the same USB port.
3. Typically, you want the StudioDock
to be your default device and
be at maximum volume. Set the
StudioDock as the default playback
device in Sound and Audio Devices
Properties in Control Panel (figure 11).
4. Set the volume by clicking the
speaker icon in the bottom right hand
corner figure 12).
Installing the StudioDock on Windows XP
Figure 12
ENGLISH