Siemens 3035isdn - Manual (Page 29)

50
Press the keys in the
specified order
Cost-effective telephoning
17.5.00 Kosten.fm Gigaset3035isdn A31008-G3035-B101-6-7619 Korrektur: 0
Setting the price per unit
Before your phone can calculate the costs for each call un-
der the “UnitsCentr.Off.” setting, you must first set the
currency and the price per unit.
 Call the menu.
< 6HWWLQJVÖÖÖÖÖÖÖÖ = Select and confirm.
< 6\VWHPVHWWLQJVÖ =
< &RVWVGXUDWLRQÖÖ =
P = Enter the base PIN (factory setting 0000) and confirm.
< KDQGORIFRVWVÖ =
< 5DWHЦЦЦЦЦ =
To display decimal places.
or
< 5DWHЦЦЦЦЦ = to display figures without decimal places.
P = Enter the cost per unit and the currency and confirm.
9 Open the supplementary menu.
6DYHHQWU\ЦЦЦЦЦЦ = Select and confirm.
Before you make the change, you will be asked “Del. a/c
alloc. for new a/cs?“. Any previously set calculations are
deleted.
<(6Ö Confirm the change.
#
and
$
The phone is in standby.
Example
Input with decimal places:
Example
Input with no decimal places:
Enter the currency. Currency
names
(e.g. DEM) can be en-
tered using the digit keys, while
currency symbols
(e.g. Euro)
can be entered using the supple-
mentary menu.
3_cd BQdU*
!"
3_cd BQdU*
!"
3ebbU^Si*
& «
51
Press the keys in the
specified order
Cost-effective telephoning
17.5.00 Kosten.fm Gigaset3035isdn A31008-G3035-B101-6-7619 Korrektur: 0
Selecting the type of display
This setting only applies to the information displayed dur-
ing a call. You can choose between
● duration of call,
● units,
● cost of the current call (call charges),
● cost of last call.
 Call the menu.
< 6HWWLQJVÖÖÖÖÖÖÖÖ = Select and confirm.
< 6\VWHPVHWWLQJVÖ =
< &RVWVGXUDWLRQÖÖ =
P = Enter the base PIN (factory setting 0000) and confirm.
< &DOOGLVSOD\ЦЦЦЦ = If the item is highlighted, the display is already set.
< Type of display = Select the type of display required.
#
and
$
The phone is in standby.
Cost conversions in the exchange
Your provider converts from “transmission of units” to
“transmission of individual call charges”
. The following
message then appears on your base station telephone dis-
play: “Please change charge units: CostsCentr.Off.“ and a
beep is emitted to signal an error.
The current counts are stored and remain unchanged dur-
ing subsequent calls. Counts only continue after conver-
sion has taken place.
The display will not show any monetary amounts until the
“CostsCentr.Off.“ accounting method is set, see also
page 49.
® If you want the costs displayed, you must first enter
the price per unit.
® The base station telephone does not always receive
the information when costs are converted. Please
remember this when comparing the telephone
costs you have calculated with the bill from your
provider.