Sanyo PDP42H2A - Manual (Page 17)

17
BEFORE OPERATION
OPEN OPEN
1 2 3
Slide the lid
upward.
Press the lid
downward
and slide it.
Remove the battery
compartment lid. Slide 2 batteries into
the compartment. Replace the compartment
lid.
REMOTE CONTROL BATTERIES INSTALLATION
Two AA size batteries
For correct polarity (+ and –), be sure
the battery terminals are in contact
with pins in the compartment.
To ensure safe operation, please observe the following precautions :
● Use (2) AA, UM3 or R06 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the Remote Control Unit to moisture, or heat.
● Do not drop the Remote Control Unit.
● If batteries have leaked on the Remote Control Unit, carefully wipe the case clean and load new
batteries.
● Risk of explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
OPERATING RANGE
Point the Remote Control Unit toward the Plasma
Monitor (Infrared Remote Receiver) whenever
pressing the buttons. Maximum operating range for
the Remote Control Unit is about 16.4’ (5m) and 60°
in front of the Plasma Monitor.
4
VOLUME – + INPUT MENU
OK
60°
16.4’ (5 m)