Sanyo PDP42H2A - Manual (Page 19)

19
BASIC OPERATION
OFF TIMER
VIDEO VIDEO
PC/D PC/DVI-D
COMPONENT
INPUT
WIDE WIDE
ON-OFF
VOLUME OLUME
OFF TIMER
MOVE UP PICTURE MUTE MUTE
STATUS MOVE DOWN MENU
POWER SURROUND
AUTO PC
OK
OFF TIMER
button
With the Off timer function, the Plasma Monitor can be set to turned off automatically after 30, 60, 90 or 120 minutes.
Pressing the OFF TIMER button on the Remote Control Unit
until the desired minutes is displayed.
Press the OFF TIMER button once to check the remaining time of Off
timer set. The remaining time will be displayed for a few seconds.
When switching input modes, the remaining time is displayed below
the selected input mode.
When remaining time reaches zero, the message "Off timer:
Power off" appears for 10 seconds, then the Plasma Monitor will
shut off; goes into standby mode.
Off timer
30
30 120 90 60 0
Off timer
58 Min.
Off timer
0 Min.
AV 1
58 Min .
1
2
Check the remaining time
Cancel the Off timer
Press the OFF TIMER button until the time "0" is displayed.
NOTE:
While the Off timer function is set, the OFF TIMER indicator lights red.
SET THE OFF TIMER
Off Timer Indications