Sanyo PDP42H2A - Manual (Page 29)

29
COMPUTER MODE
SELECTING INPUT SOURCE
SELECTING COMPUTER SYSTEM
This Plasma Monitor automatically tunes to most different types of computers based on VGA, SVGA or XGA (refer to
“COMPATIBLE COMPUTER SPECIFICATIONS” on page 32). When selecting PC for the input mode, this Plasma Monitor
automatically detects the incoming signal and displays a proper image without any special setting. (Some computers need
manual setting.) If the Monitor may not be able to display a proper image, the following messages will be displayed.
When the Plasma Monitor detects any signal out of the system formats provided in the
Compatible Computer Specifications on page 32 of this manual, the message “Out of scan
range” will be displayed for a few seconds.
There is no signal input from the computer. Make sure the connection of the computer and the
Plasma Monitor.
Out of scan range
No signal
REMOTE CONTROL OPERATION
Select "PC" or "DVI-D" by pressing the PC/DVI-D button on the
Remote Control Unit.
FRONT CONTROL OPERATION
Select "PC" or "DVI-D" by pressing the INPUT button on the Front
Control of the Plasma Monitor. (Refer to P21)
PC
DVI (PC)